DIY Skyrim Windhelm Shield: Finished

Read part one here.

Day Three: I started painting the rim to look like aged metal by mixing black and silver acrylic and painting two base coats on top of the Plasti-Dip coated craft foam. I then dry-brushed on a thin layer of silver, highlighting the raised parts of the rim. After the paint was entirely dry, I mixed orange, brown, and a small amount of red paint to create a rust colour. I watered down the paint and with a wet brush, I created pools of paint wherever I wanted there to be rust. I tuck to the burnt in depressions in the foam, and places where the Plast-Dip had bubbled. After a minute of soaking, I used a paper towel to remove most of the paint.Once this had dried I noticed a few spots which needed a touch up, so I used the appropriate colour paint to apply small fixes. Then, I sealed the rim with two thin layers of modge podge. By this point, I had decided that I wanted to finish the back side of the shield as well, so I removed the bag and tape from the back side of the shield and stained the exposed wood.

Day Four: I started by removing the bag and masking tape from the front of the shield. I noticed that the blue paint needed another coat so I added one before moving on. With the chisel tip on my wood burner, I added the planked look to the back of the shield. I made the decision not to use the single, dead centre handle that is seen in game. Instead, I created a double strap hand out of double layered foam. This turned out to be a horrible idea since the first time I used it, the foam broke. Instead, I lay two pieces of foam down where I wanted the handles to be to serve as padding against the hard wood, then I cut two pieces from an old belt to fit on top. I secured the belts in place with screws and washers which passed through the belt and foam into the wood of the shield.

As usual, I learned I great deal on how not to do things. Doing, this project again (cough* Solitude) I would stain the project last, since I found that paint which overlapped with the stain required several extra coats. I wouldn’t carve out the rim in wood, since the foam rim looks much better than that would have. That was a good chunk of time which ended up being wasted. I’d also burn planks into both sides to begin with and go straight for propper strapping.

The shield was finally complete! I’m really happy with the way the shield turned out. It’s a sturdy build, and the bright logo (while note game accurate) really stands out against the battle worn look of the shield. You gotta to keep up that Stormcloak pride, am I right?


3 thoughts on “DIY Skyrim Windhelm Shield: Finished

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s